SETTING INSTRUCTIONS FOR SEIKO H556 & H558 MOVEMENT
(by Roland Kamp, September 2003)
Notes on different time zones. This watch has three different time zones:
• Analog time.
• Digital time.
• Second digital time, also called local-time, displayed with "-L" in the right corner
of the display.
These three time (zones) work independently, the alarm and hourly chime always refer to
the digital time.
Set analog time.
• Pull crown to position 3, the secondhand stops.
• Set the hands to the correct time by turning the crown in direction X.
• Push the crown back to position (1) to start the analog part of the watch again.
Set digital time.
Switch alarm and hourly chime on/off.
• Push button B until the alarm time is on the display, AL in the right corner of
display.
• Pull crown to position 2 and after 1 second push it back to position 1 again.
Repeat this
• Action until desired function is set, see table below.
Alarm
Hourly chime
Off
On
Blinking
Off
On
On
Off
Off
On
Stopwatch.
• Push button B until the stopwatch is on the display
• Push button A to start and stop timing.
• Hold button A pressed for a second to reset the stopwatch.
• Stopwatch keeps running when changing to a different mode.
Light.
• Push button A to illuminate the digital display. Does not work in stopwatch mode.
Alarm test.
• Push buttons A and B simultaneously to sound the alarm.
|