LCD PROJECTOR LENS
MODEL NO. LNS-M01
LNS-S01
LENS REPLACEMENT AND
INSTALLATION PROCEDURE
NOTES ON LENS INSTALLATION
Lens installation should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to install the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
If you have any questions, contact to the dealers.
PARTS LIST
Following parts are contained in the packing.
· LENS
1 piece
· LENS MOUNTING SCREWS
· DRIVER
6 screws (2 for spare)
1 piece
· LIGHT-BLOCK SHEET
1 sheet
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet assembly after the
lens installation.
1. Confirm the lens is securely fixed by 4 screws.
2. Wiring must not be tangled in the gear of the lens motor or the other
mechanical part.
3. There is no missing part, or no loosing mounting part.
1AA6P1P1980-- (ICPP)
INSTALL THE LENS. (See figure-4,5.)
3
LENS MOUNTING BRACKET
1. Mount the lens at the lens
mounting bracket with screws
(4 screws) included with the
lens. Use the driver included
with the lens to fasten the
screws . (After using, save it for
latter use.)
ATTACHED DRIVER
2. Connect the lens motor lead to
the connector “K16B” of the cir-
cuit board.
3. Fasten the lens motor lead at
the A, B points with wire holder.
Fig-4
LIGHT-BLOCK SHEET
❋ Figure shown inside of the cabinet.
LENS MOTOR
(D)
(D)
(D)
(D)
B
A
WIRE HOLDER
This part wiring should
not be tightened.
LENS
MOTOR LEAD
Fig-5
CONNECTOR “ K16B “
MOUNT THE LENS COVER. (See figure-1)
4
When in install the both upper and lower lens covers,
put the light-block sheet through the lens and install
the sheet so that it should be placed in the guide slot
of the lens cover. If the installation of the light-block
sheet is incorrect, there will be the space between
lens and the lens cover, so that it will be the cause of
leakage of light or the dust entering at the main cab-
inet.
|