Ruby Tech Switch ES 2310C User Guide

R
RUB  
TECH  
Fast EthernetSwitch  
L2 Managed Switch  
Networking & Communications  
ES-2310C  
ES-2310C:  
8-Port L2 Managed Fast Ethernet Switch with 2 SFP Gigabit Dual Media  
Benefits  
QoS with four priority queues  
Key Features  
Standard compliance  
The QoS(Quality Of Service) feature provides four internal queues to support  
four different classifications of traffic. High priority packet streams experience  
less delay inside the switch, which supports lower latency for certain delay-  
sensitive traffic. The ES-2310C can classify the packet as one of the four  
priorities according to vip port, 802.1p priority tag, DiffServ and/or IP TOS.  
The QoS operate at full wire speed. The actual scheduling at each egress  
port can be based upon a strict priority, weighted round robin or a mix of both.  
Port Mirroring  
---IEEE 802.3 10Base-T  
---IEEE 802.3u 100Base-TX  
---IEEE 802.3ab 1000Base-TX  
---IEEE 802.3z 1000Base-X Ethernet  
---IEEE 802.3x flow control capability  
---ANSI/IEEE 802.3 auto-negotiation  
---IEEE 802.1q VLAN  
RoHS Compliance  
This mechanism helps track network errors or abnormal packet transmission  
without interrupting the flow of data. Allow ingress traffic to be monitored by a  
single port that is defined as mirror capture port. The mirror capture port can  
be any 10/100 port, 10/100/1000 port. Mirroring multiple ports is possible but  
can create congestion at the mirror capture port.  
Subscriber Interface  
---8 are 10/100Mbps and 2 Gigabit  
Ethernet ports.  
---Port 9,10 are Gigabit TP/SFP Fiber  
auto sense  
Q-in-Q VLAN for performance & security  
---Auto-Negotiation and Auto-MDIX  
---Back pressure flow control for half  
duplex.  
The VLAN feature in the switch offers the benefits of both security and  
performance. VLAN is used to isolate traffic between different users and thus  
provides better security. Limiting the broadcast traffic to within the same VLAN  
broadcast domain also enhances performance. Q-in-Q, the use of double  
VLAN tags is an efficient method for enabling Subscriber Aggregation. This is  
very useful in the MAN.  
---IEEE 802.3x compliant for full duplex  
---Connector: 8 RJ-45 and 2 dual media,  
RJ-45/SFP  
Performance  
Isolated Group, provides protection for certain ports  
Switching capacity:  
The isolated group feature allows certain ports to be designated as protected.  
All other ports are non-isolated. Traffic between isolated group members is  
blocked. Traffic can only be sent from isolated group to non-isolated group.  
Mac-based 802.ad LACP with automatic link fail-over  
---Non-blocking switch fabric supports up  
to 8 FE+2GbE ports  
---8 K MAC addresses  
---256K packet buffer and 128K control  
memory  
Dynamic fail-over means packets will not get assigned to any trunk member  
port that has failed. If one of the ports were to fail, traffic will automatically get  
distributed to the remaining active ports.  
VSM(Virtual Stacking Management)  
---Supports 16 devices stacking  
---Multiple switches can be managed via  
one IP address, just like software  
stacking  
802.1x Access Control improves network security  
802.1x features enable user authentication for each network access attempt.  
Port security features allow you to limit the number of MAC addresses per  
port in order to control the number of stations for each port. Static MAC  
addresses can be defined for each port to ensure only registered machines  
are allowed to access. By enabling both of these features, you can establish  
an access mechanism based on user and machine identities, as well as  
control the number of access stations.  
---Low cost and easily to establish  
network environment, not extra  
hardware require  
---Not center on the physical location of  
wiring closets  
802.1d Compatible & 802.1w Rapid Spanning Tree  
VLAN  
For mission critical environments with multiple switches supporting STP, you  
can configure the switches with a redundant backup bridge path, so  
transmission and reception of packets can be guaranteed in event of any  
fail-over switch on the network.  
---Supports SVL/IVL configuration to  
meet your VLAN requirement  
---Port-base VLAN  
---IEEE802.1q tag-base VLAN, 4094  
max, up to 256 active VLANs including  
static plus dynamic entry  
---IEEE802.1q tag-base VLAN  
2 dual media ports for flexible fiber connection  
Port 9, 10 dual media ports are provided for flexible fiber connection. You can  
select to install optional transceiver modules in these slots for short, medium  
 
R
RUB  
TECH  
Fast EthernetSwitch  
L2 Managed Switch  
Networking & Communications  
---Static mac, to limit which mac  
addresses can pass through or not  
---Mac addresses learning limit, to set up  
the maximum amount of mac that  
each port can learn  
Snmpv1,v2c Network Management  
RFC 1213 MIB (MIB-II)  
Interface MIB  
Ordering Information  
ES-2310C:  
8-Port L2 Managed Fast Ethernet Switch with 2 SFP Gigabit Dual Media  
Optional SFP Fiber Module (See note below)  
SFP.LC  
1000Base-SX GE SFPMulti-Mode Fiber Module 850nm  
1000Base-SX GE SFPFiber Module, LC Multi-Mode  
1310nm 2km  
SFP.LC.M2  
Address Translation MIB  
IP MIB  
SFP.LC.S10 1000Base-LX GE SFPSingle-Mode 10Km Fiber Module  
1310nm  
ICMP MIB  
SFP.LC.S30 1000Base-LX GE SFPSingle-Mode 30Km Fiber Module  
TCP MIB  
1310nm  
UDP MIB  
SFP.L5.S50  
1000Base-LX GE SFPSingle-Mode 50Km Fiber Module  
1550nm  
SNMP MIB  
RFC 1757 RMON MIB  
Statistics Group 1  
SFP.BL5.S10 1000Base-LX GE SFPBiDi_LC 10Km Module Single  
Fiber 1550nm, Type 1  
History Group 2  
SFP.BL3.S10 1000Base-LX GE SFPBiDi_LC 10Km Module Single  
Fiber 1310nm, Type 2  
Alarm Group 3  
Event Group 9  
SFP.BL5.S20 1000Base-LX GE SFPBiDi_LC 20Km Module Single  
Fiber 1550nm, Type 1  
RFC 1493 Bridge MIB  
RFC 1643 Ethernet MIB  
Enterprise MIB  
SFP.BL3.S20 1000Base-LX GE SFPBiDi_LC 20Km Module Single  
Fiber 1310nm, Type 2  
Note:  
Overview  
We recommend the SFP transceiver from the following vendors:  
1. Ruby Tech Corporation  
2. Agilient Technologies  
3. AVAGO Technologies  
4. Finisar Corporation  
ES-2310C is a Managed Fast Ethernet  
switch that supports SNMP, Web UI and  
CLI management interface and with 8 10/  
100Base-TX (RJ-45 connectors) and 2  
Gigabit dual media (RJ-45/SFP or RJ-45/  
GBIC) ports. It is a standard switch that  
meets all IEEE 802.3/u/x/z Gigabit, Fast  
Ethernet specifications. In addition, the  
switch implements the QoS (Quality of  
Service), VLAN, Mac Filtering Policy, Port  
Mirror, VLAN and full L2 protocols. It has  
a rich feature set suitable for streaming  
VoIP, video, and data traffics for multimedia  
applications.  
In this switch, Port 9, 10 support two types  
of media --- TP and SFP/GBIC Fiber (LC,  
BiDi-SC....); both ports support 10/100/  
1000Mbps TP or 1000Mbps SFP/GBIC  
Fiber with auto-detected function.  
1000Mbps SFP/GBIC Fiber transceiver  
is used for high-speed connection  
expansion.  
Ruby Tech Corp.  
3F, No.1, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan  
TEL:886-2-2785-3961 FAX:886-2-2786-3012  
Technical information listed is subject to change without prior notice. All brand names and trademarks are property of their respective owners.  
 
Copyright  
c
2008 Ruby Tech Corp. All rights reserved.  
2008-07.30 Version A  

RCA DVD VCR Combo DRC6355N User Guide
ResMed Portable Generator S8 Elite System User Guide
Roadmaster Car Speaker VR690 User Guide
Roland Musical Instrument KR 117 User Guide
Roper Oven B875 User Guide
Rosewill Modem RNX 56AG User Guide
Rosewill TV Mount RMS MA2740 User Guide
Samson Portable Speaker RS10 User Guide
Samsung Oven BT621 Series User Guide
Sears Saw 31510924 User Guide