QUICK START
ENGLISH
43-3107
Indoor/Outdoor Modular
Intercom System
Refer to your Owner’s Manual for complete instructions.
PREPARATION
1. Remove the doorbell’s battery compartment
cover.
8. If desired, mount the indoor intercom using
the supplied anchors and screws as shown.
Doorbell Intercom
BELL — Press
to sound the
indoor
intercom.
2. Insert 4 AA batteries.
PRESS TO TALK —
Hold down to talk to
the other person.
3. To change the doorbell
tone, use a flat blade
screwdriver to remove
TONE, and insert it into
the other two pins.
1 2 3 OUTDOOR
CHANNEL — Set
to the same
channel as the
doorbell
A B C CHANNEL —
OPERATION
Set multiple
4. Slide CH 1 2 3 to the
same channel as the
indoor intercom.
intercoms to the
1. Rotate VOLUME on the indoor intercom
same channel to
communicate with
them.
counterclockwise until it clicks. Then
adjust VOLUME to the desired listening
5. Slide VOL 1 2 3 to the desired volume and
intercom.
Indoor Intercom
level.
replace the cover.
2. To turn off the indoor intercom, rotate
6. Plug the indoor
intercom into a
VOLUME —
Adjusts
volume and
powers it on
VOLUME clockwise until it clicks.
standard AC outlet.
3. Press BELL on the doorbell to sound the
indoor intercom. Hold down TALK TO
DOOR on the indoor intercom to reply.
When you release TALK TO DOOR, the
caller can reply by holding down PRESS
TO TALK on the doorbell intercom.
and off.
7. Mount the doorbell
using the supplied
bracket, anchors,
and screws as
shown.
TALK TO DOOR —
Hold down to talk to
the other person.
TALK — Hold down to
talk over the intercom.
CALL — Press to sound an
alert tone to the other station.
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
|