12-1632.fm Page 1 Wednesday, May 10, 2000 10:57 AM
Cat. No. 12-1632
OWNER’S MANUAL
Please read before using this equipment.
AM/FM PLL Clock/Table Radio
12-1632.fm Page 3 Wednesday, May 10, 2000 10:57 AM
PREPARATION
Follow these steps to install back-up bat-
teries.
CONNECTING TO AC
POWER
1. Slide the battery compartment cover
in the direction of the arrow and
remove it.
Plug the clock radio’s power cord into a
standard AC outlet. The display turns on
and the BATTERY SENTINEL indicator
lights. (See “Installing Back-Up Batteries.”)
2. Place the batteries in the compart-
ment and on top of the attached rib-
bon, as indicated by the polarity
symbols (+ and –) marked in the com-
partment.
Caution: The clock radio’s AC power cord
is equipped with a polarized plug to pre-
vent electric shock. One blade on the
cord’s plug is wider than the other and the
plug only fits an outlet one way. If you can-
not easily insert the plug, turn it over and
try again. Do not force it.
3. Replace the cover.
The BATTERY SENTINEL indicator lights
if the back-up batteries are not installed or
need to be replaced.
Warning: Always dispose of old batteries
promptly and properly. Do not bury or burn
them.
INSTALLING BACK-UP
BATTERIES
To keep the clock running for up to 8 hours
during an AC power failure, install three
AA batteries (not supplied) in the battery
compartment. For the longest life, we rec-
ommend alkaline batteries.
Caution: Use only fresh batteries of the
required size and recommended type.
Note: To prevent unnecessary drain on
the battery, connect AC power then install
the batteries.
3
12-1632.fm Page 4 Wednesday, May 10, 2000 10:57 AM
A QUICK LOOK AT THE CONTROLS
Operation
Selectors
Radio/Alarm
Selector
Station Mem-
ory Selectors
SNOOZE Bar
Alarm
Setting
Indicator
Sleep
Timer
Indicator
Display
Brightness
Switch
Time Setting
Indicator
AM/PM
Indicator
Alarm Indicator
Station
Memory
Indicator
SLEEP MEM
Battery Sentinel
Indicator
Radio Station
Tuning Bar/
Hour-Minute
Setting Bar
4
12-1632.fm Page 5 Wednesday, May 10, 2000 10:57 AM
OPERATION
SETTING THE TIME
TURNING THE ALARM
ON/OFF
1. Press MODE. The time and
appear.
To have the buzzer sound or the radio turn
on at the set alarm time, set RADIO ON-
OFF/ALARM AUTO-ALARM to ALARM for a
buzzer alarm or to AUTO to have the radio
play as the alarm.
2. Hold down MEMORY/TIME then
repeatedly press (or hold down) 9
HOUR until the display shows the cor-
rect hour setting.
To set the alarm, press ALARM ON/OFF.
Note: PM appears when you set a PM
hour. AM appears for an AM hour.
appears. At the preset time
flash-
es and the buzzer sounds or the radio
turns on for up to 2 hours.
3. Hold down MEMORY/TIME then
repeatedly press (or hold down) MIN
8 until the display shows the correct
minute setting.
To cancel the alarm, press ALARM ON-
OFF.
disappears and the alarm (buzz-
er or radio) stops. To have the alarm
sound the next day at the set time, press
CHANGING THE DISPLAY
BRIGHTNESS
ALARM ON/OFF again so
appears.
To turn on the radio at any time, set RADIO
ON-OFF/ALARM AUTO-ALARM to RADIO
ON. Move the switch to either ALARM or
AUTO to turn off the radio and set the
alarm again.
To change the brightness of the display,
set DIM HI/LO to HI or LO.
SETTING THE ALARM
TIME
Notes:
• To adjust the alarm volume, rotate
VOL.
1. Repeatedly press MODE until SET
ON and the current alarm time appear.
• During a power failure, the alarm
sounds instead of the radio regardless
of how you set RADIO ON-OFF/ALARM
AUTO-ALARM.
Note: If you do not set the alarm time
within 10 seconds, the clock radio dis-
plays the previous function. To con-
tinue, start over at Step 1.
2. Hold down MEMORY/TIME then
repeatedly press (or hold down) 9
HOUR until the display shows the
desired alarm hour setting.
USING SNOOZE
To temporarily silence the alarm or radio,
for about 5 minutes, press SNOOZE. You
can repeat this cycle as many times as you
like. To turn off the alarm so it does not
sound again, press ALARM ON/OFF.
3. Hold down MEMORY/TIME then
repeatedly press or hold down MIN 8
until the display shows the desired
alarm minute setting.
5
12-1632.fm Page 6 Wednesday, May 10, 2000 10:57 AM
PLAYING THE RADIO
USING THE STATION
MEMORIES
1. Turn VOL to a medium setting, then
set RADIO ON-OFF/ALARM AUTO-
ALARM to ON. The frequency of the
last tuned station appears.
You can store up to 20 stations (10 AM
and 10 FM) into memory and quickly recall
each. Follow these steps to store a station.
2. Press AM/FM to select the desired
1. Turn on the radio and select the desired
band (see “Playing the Radio” ).
band.
Notes:
2. Press MEMORY/TIME. MEM appears.
• The clock radio has a built-in
antenna. For the best AM recep-
tion, rotate the radio.
3. Press
a
memory button (M1–M5)
within 3 seconds to store the station.
The memory number appears and the
station is stored. To store a station in
locations 6 to10, press MEMORY/TIME
and +5, then press one of the memory
buttons (M1 for 6, M2 for 7, and so on).
Memory location 10 appears as 0.
• The FM antenna is built into the
power cord. For the best FM recep-
tion, fully extend the clock radio’s
power cord.
3. Repeatedly press MIN 8 or 9 HOUR
to tune up or down to the desired sta-
tion. To automatically seek and tune to
the next strong station, hold down
TUNING MIN 8 or 9 HOUR for about
2 seconds.
Notes:
• If you do not store a station within 3
seconds, MEM disappears. Begin
again at Step 2 to store the station.
• To replace a stored station, simply
store a new one in its place.
4. Rotate VOL to the desired volume.
5. To turn off the radio, slide RADIO ON-
OFF/ALARM AUTO-ALARM to RADIO
OFF.
4. To tune to a stored station, press that
station’s memory button. The memory
location and the stored station’s fre-
quency appear. To recall a stored sta-
tion from 6 to 10, press +5 then the
memory button
Notes:
• If you play the radio and want be cer-
tain that the radio sounds at the alarm
time, be sure to set RADIO ON-OFF/
ALARM AUTO-ALARM to AUTO instead
of RADIO OFF when you finish playing
the radio.
USING THE SLEEP TIMER
You can set the radio to play for up to 90
minutes then automatically turn off.
• To display the time while the radio
plays, repeatedly press MODE until
1. Tune to the desired station.
the time and
appear. To return to
2. Set RADIO ON-OFF/ALARM AUTO-
the station frequency display, repeat-
edly press MODE until the station fre-
quency appears.
ALARM to OFF, AUTO, or ALARM.
6
12-1632.fm Page 7 Wednesday, May 10, 2000 10:57 AM
3. To have the radio play for 90 minutes
then automatically turn off, press
SLEEP. SLEEP and 90 appear.
THE FCC WANTS YOU TO
KNOW
To have the radio play for less than 90
minutes, hold down SLEEP. The dis-
played time decreases in 10-minute
increments as you hold down SLEEP.
Release SLEEP when you reach the
desired play time.
Your clock radio might cause TV or radio
interference even when it is operating
properly. To determine whether your clock
radio is causing the interference, turn off
your clock radio. If the interference goes
away, your clock radio is causing the inter-
ference. Try to eliminate the interference
by:
4. To turn off the radio before it automati-
cally turns off, press SNOOZE or press
SLEEP again.
• moving your clock radio away from
the TV or radio
Note: Using the sleep timer feature does
not cancel an alarm setting.
• connecting your clock radio to an out-
let that is on different electrical circuit
from the receiver
• contacting your local RadioShack
store for help
CARE
To enjoy your RadioShack AM/FM PLL
Clock/Table Radio for a long time:
If you cannot eliminate the reference, the
FCC requires you that you stop using your
radio.
• Keep the clock radio dry. If it gets wet,
wipe it dry immediately.
• Use and store the clock radio only in
normal temperature environments.
SPECIFICATIONS
• Handle the clock radio gently and
carefully. Do not drop it.
Frequencies:
AM ................................ 530–1710 kHz
FM ................................... 88–108 MHz
• Keep the clock radio away from dust
and dirt.
Output Power ......... 350 mW at 10% THD
• Wipe the clock radio with a damp
cloth occasionally to keep it looking
new.
Power Sources:
Clock/Radio ........................... 120V AC
Battery Back Up ...... 4.5 V DC (3 × AA)
Modifying or tampering with the
clock ra-
4
4
5
5
Dimensions (HWD) ......... 6 × 4 / × 2 / in
’s internal components can cause a
dio
(152 × 122 × 72 mm)
malfunction and might invalidate its war-
ranty and void your FCC authorization to
Weight (without batteries):........... 1 lb 6 oz
(625 g)
use it. If your
is not performing
clock radio
as it should, take it to your local Ra-
dioShack store for assistance.
Specifications are typical; individual units
might vary. Specifications are subject
change and improvement without notice.
7
12-1632.fm Page 8 Wednesday, May 10, 2000 10:57 AM
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing defects in material and workman-
ship under normal use for ninety (90) days from the date of purchase from RadioShack company-
owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED
HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES,
INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES
CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABIL-
ITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RE-
SPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE
OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WAR-
RANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVE-
NIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN AD-
VISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limita-
tion of incidental or consequential damages, so the above limitations or exclusions may not apply to
you.
In the event of a product defect during the warranty period, take the product and the RadioShack
sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, un-
less otherwise provided by law: (a) correct the defect by product repair without charge for parts and
labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase
price. All replaced parts and products, and products on which a refund is made, become the prop-
erty of RadioShack. New or reconditioned parts and products may be used in the performance of
warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the
expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse,
accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or
maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as
fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs
of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
12/99
We Service What We Sell
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
12A99
Printed in the Philippines
|