RT-2M (90007891000) Quick Start Guide
INCLUDED PARTS:
•
•
RT-2M Unit
DB-9 Cable
NOTE:
See the entire system diagram on reverse side.
Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the Step 2. Cable the RT-2M to the Frame.
RT-2M.
RS-232 Cable Pinout
To cable the RT-2M to the Frame, do the following:
NOTE:
In Trunk Supervisor, you must designate
the intercom and port number the RT-2M
sends the test signal over.
1. Using the appropriate connector defined below, connect the
RT-2M to the Frame:
CONNECTOR
CONNECTION
To cable the Trunk Supervisor/TrunkEdit PC to the
RT-2M, do the following:
•
•
•
•
Plug pins 2 and 5 into the Ch 1 input connector terminals.
RJ-12
Plug pins 3 and 4 into the Ch 1 output connector terminals.
Plug pins 7 and 8 into the Ch 1 input connector terminals
Plug pins 4 and 5 into the Ch 1output connector terminals.
1. Using the included cable, connect a COM port on
the Trunk Supervisor computer to the RS-232
DB-9
Interface connector on the rear panel of the RT-2M.
2. Connect the other end of the connector to the trunking
connection port as defined in the Trunk Supervisor software.
LIT000306000 Rev. A
11/2008
|
Radio Shack Automobile Accessories 60 4395 User Guide
Radio Shack Network Cables 273 1687 User Guide
Reebok Fitness Home Gym RBEX33190 User Guide
Renesas Computer Hardware M38C59T RLFS User Guide
Rugged Outback Switch RS416 User Guide
Saab Automobile 5 Sep User Guide
Samsung All in One Printer SCX 4016 User Guide
Samsung Microwave Oven ME1060BB User Guide
Seiko Group Printer BP 9000 User Guide
Seiko Watch CAL 7T94 User Guide