Wireless Headphones
with 900 MHz transmitter
up to
*
feet
Thank you for choosing the
RCA Wireless Headphones.
Before attempting to use
your Wireless Headphones,
please remove all parts from
the box and read
the installation and use
instructions carefully.
* Open field tested
Limited One-Year Warranty
WHP140
TABLE OF CONTENTS
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Transmitter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Headset safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
INTRODUCTION
This 900 MHz stereo wireless headphone system features a compact
design that uses the latest wireless technology that enables you to
enjoy music and TV sound just about anywhere inside or outside your
home. You can simply connect the system to any sound source, such
as a DVD, DBS, CD, TV, VCR, stereo receiver and radio.
FEATURES
900 MHz RF technology lets you roam freely throughout your house
Operating distance up to 100 feet
No line-of-sight limitation
Convenient power and tuning controls located on headphones
ꢀ
TRANSMITTER
FRONT
BACK
POWER LED
INDICATOR
CHANNEL TuNINg WHEEL
BuILT-IN 3.5mm
sTEREO AuDIO
CORD
DC POWER JACK
HEADSET SAFETY
■
■
■
Do not play your headset at a high volume.
Hearing experts advise against continuous extended play.
If you experience a ringing in your ears, reduce the volume
or discontinue use.
Make sure the volume level of the headphone is set at a comfortable
listening level before placing it in position over your ears.
ꢁ
INSTALLATION
Please follow this quick set-up guide to ensure trouble free installation
of your headphones.
Step 1:
Connect the built-in 3.5mm Stereo Audio Cord to the audio output
jack of your audio source, e.g. TV, HiFi, CD, DVD player etc. The 3.5mm
plug is standard and will fit in the jack marked PHONES or
LINE OUT that is available on most portable CD, MP3 players or
portable audio device.
* If you are connecting to a stereo receiver or if your audio source has
two RCA output jacks (red and white in color), use the Y-connection
Cord that is included for connecting the transmitter to the
the jacks marked AUDIO OUT or LINE OUT.
Step 2:
Connect the plug end of the AC Adapter to the DC IN Socket,
located on the back of the transmitter, and plug the adapter into
the AC wall outlet.
Important: This power unit is intended to be correctly oriented in a
vertical or floor mount position.
Step 3:
The transmitter is now ready to receive an audio signal. When there
is a signal received from the audio source, the Power LED Indicator
will glow RED to confirm that the transmitter is operating.
Make sure the transmitter is located on a secure flat surface, preferably
above head level. This will assure the best performance and allow the
headphone to receive the wireless signal.
* The transmitter has an auto-cut-off function. When there is no audio
signal (such as when a CD has finished and the player stops) for
a period of about 90 seconds, the power of the transmitter will be
automatically cut off. You will then hear some noise from the headset
and the LED on the earcup will turn RED. Once an audio signal is
restored to the transmitter (resume playing the CD or audio program)
then the LED on the transmitter will glow RED indicating that it is
transmitting audio once again (the LED on the headphone will turn
back to GREEN to indicate normal operation).
ꢂ
INSTALLATION (continued)
Step 4:
Placing your thumb on the Battery Compartment Cover on the left
side of the headphone, gently push up in a sliding motion to remove
the cover. Then insert the 2 “AA” size batteries into the battery
compartment, carefully following the markings inside to assure the
batteries are inserted properly with the + and – ends in the correct
position. Then slide the battery cover into place until the tabs lock
to secure it in the proper position. Then locate the Power ON/OFF
Switch and slide it to ON.
*Note: You may use nickel-cadmium or nickel-metal hydride
rechargeable batteries to operate the headphones. However, they
may not be recharged in the headphones. Use your charging device
with the batteries to recharge them.
Do not mix batteries with different chemistry types (for example, a zinc
battery with an alkaline battery). Do not mix new and used batteries.
Do not leave batteries installed in the product when not in use for long
periods.
RIGHT SIDE
LEFT SIDE
BATTERy
COmPARTmENT
COvER
DuAL
COLOR LED
INDICATOR
POWER ON/
OFF sWITCH
CHANNEL
vOLumE
CONTROL
KNOB
TuNINg
THumBWHEEL
ꢃ
INSTALLATION (continued)
Step 5:
Switch on your music device (TV, HiFi, CD, DVD etc.) to begin
playing your audio program. If you have the transmitter connected
to a portable CD or MP3 player, make sure the volume level on the
player is set to a mid-level setting to assure a strong input signal to
the transmitter.
Step 6:
Listen to the sound coming from the headphone before placing it in
position on your head to make sure the volume is not too loud. Adjust
the volume control by rotating the thumbwheel to the desired level.
Please refer to the previous HEADSET SAFETY section for quidelines
on operating safety.
If there is no sound or it is distorted, then tune the headphone by
adjusting the CHANNEL TUNING THUMBWHEEL until the sound
is improved and the LED light turns GREEN.
ꢄ
OPERATION
1. Turn on the audio source (TV or audio component) to which the
transmitter is connected.
2. Slide the ON/OFF switch on the headphone to “ON.”
3. Listen to the volume coming from the ear cups on the headphone to
make certain that the volume is not too loud before placing the unit
on your head. (See the section titled “Headset Safety” on page 1.)
Adjust the volume as needed using the VOLUME CONTROL wheel
located on the right ear cup. Once the volume level is at a comfortable
setting, place the headphones over your ears and adjust the volume
as desired.
ꢅ
SPECIFICATIONS
Model
WHP140
Description
Radio Frequency
Wireless Headphones System
(Power Auto Cut Off/Dual Color
LED Indicator)
Transmitter
Carrier Frequency
900 MHz
Effective Range
Power Supply
100 feet (open field)
AC Adapter, 12V 200mA
Headphones
Frequency Response
100-7,000 Hz
Signal to Noise Ratio
Distortion
50 dB
<2%
Channel Separation
Power Supply
25 dB
2 x 1.5V AA size batteries
System Includes
1 Transmitter
(built-in 3.5mm stereo audio cord)
1 Headphones
1 AC/DC adapter for transmitter
1 Y-connection Cord
2 AA heavy duty batteries
ꢆ
TROUBLESHOOTING
If you encounter any trouble in setting up the Headphones,
please check the following points:
PROBLEM
SOLUTION
Distorted sound
quality or
unclear sound:
A) Check if the sound of your audio source is
distorted and whether the volume control
is set to an adequate level.
B) Make sure that your audio equipment, the
transmitter and headphones are connected
properly and switched ON. If the batteries
in the headphones have insufficient power,
replace them with fresh batteries.
C) Check if you have selected the best channel.
Adjust the Channel Tuning once again to
check. If necessary, you may change the
setting of the transmitter by turning the
CHANNEL TUNING THUMBWHEEL up
or down, then adjusting the thumbwheel
on the HEADPHONES to tune in a better
channel setting to improve audio or
eliminate interference.
No sound from
the headphones:
A) Check if the batteries are inserted properly
into the battery compartment and whether
the headphones are switched ON.
B) Check if the batteries in the headphones
have sufficient power—replace them
if necessary.
c) Check if the transmitter is properly
connected and powered on with the AC/
DC Adapter (the Power LED
Indicator should glow RED).
D) Check if all the cords are properly connected.
E) Check if the distance between the
headphones and transmitter are within the
effective range. (The effective range of the
device is approx. 100 feet). Move closer to
the transmitter to receive the sound.
Mono sound:
A) Check if the audio source is mono only,
use a stereo audio source.
10
TROUBLESHOOTING (continued)
PROBLEM
SOLUTION
Interference:
A) On the back of the transmitter, there is a
CHANNEL TUNING THUMBWHEEL.
Select a different frequency channel by
turning the thumbwheel up or down. Then
adjust the thumbwheel on the channel
tuning control on the headphones until the
LED Indicator glows GREEN showing that
the channel has been properly tuned.
Power auto-cut-off:
A) The transmitter has an auto-cut-off function.
When there is no audio signal (such as
when a CD has finished and the player
stops) for a period of about 90 seconds,
the power of the transmitter will be
automatically cut off. You will then hear
some noise from the headset and the
LED on the earcup will turn RED. Once an
audio signal is restored to the transmitter
(resume playing the CD or audio program),
then the LED on the transmitter will glow
RED indicating that it is transmitting audio
once again (the LED on the headphone
will turn back to GREEN to indicate
normal operation).
11
12 MONTH LIMITED WARRANTY
Audiovox Electronics Corporation (the “Company”) warrants to the original retail
purchaser of this product that should this product or any part thereof, under normal use
and conditions, be proven defective in material or workmanship within 12 months from
the date of original purchase, such defect(s) will be repaired or replaced (at the Company’s
option) without charge for parts and repair labor. To obtain repair or replacement within
the terms of this Warranty, the product along with any accessories included in the
original packaging is to be delivered with proof of warranty coverage (e.g. dated bill of
sale), specification of defect(s), transportation prepaid, to the Company at the address
shown below. Do not return this product to the Retailer.
This Warranty is not transferable and does not cover product purchased, serviced or used
outside the United States or Canada. The warranty does not extend to the elimination
of externally generated static or noise, to costs incurred for the installation, removal or
reinstallation of the product. The warranty does not apply to any product or part thereof
which, in the opinion of the company, has suffered or been damaged through alteration,
improper installation, mishandling, misuse, neglect, accident or exposure to moisture.
This warranty does not apply to damage caused by an AC adapter not provided with the
product, or by leaving non-rechargeable batteries in the product while plugged into an
AC outlet.
THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS
LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO
EVENT, SHALL THE COMPANY’S LIABILITY EXCEED THE PURCHASE PRICE PAID
BY PURCHASER FOR THE PRODUCT.
This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED
WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO DURATION OF
THIS WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER,
INCLUDING ANY IMPLIED WARRANTY, MUST BE BROUGHT WITHIN A PERIOD
OF 24 MONTHS FROM THE DATE OF ORIGINAL PURCHASE. IN NO CASE
SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL
DAMAGES WHATSOEVER. No person or representative is authorized to assume for
the Company any liability other than expressed herein in connection with the sale of
this product. Some states/provinces do not allow limitations on how long an implied
warranty lasts or the exclusion or limitation of incidental or consequential damage so the
above limitations or exclusions may not apply to you. This Warranty gives you specific
legal rights and you may also have other rights which vary from state/province to
state/province.
U.S.A.: Audiovox Electronics Corporation, 150 Marcus Blvd.,
Hauppauge, New York 11788
CANADA: Audiovox Return Center, c/o Genco, 6685 Kennedy Road, Unit 3, Door 16,
Mississauga, Ontario L5T 3A5
© 2007 Audiovox Accessories Corporation
111 Congressional Blvd., Suite 350
Carmel, IN 46032 USA
WHP140 US IB 01
Trademark(s) ® Registered
Marca(s) Registrada(s)
Made in China
|